v.: 2020-09-04
Copyright of the European Union is effective (Copyright EU) (c) 2019 GENEREX Systems GmbH, Hamburg, Germany, All rights reserved
TEL +49(40)22692910 - EMAIL generex@generex.de - WEB www.generex.de (This and all other product datasheets are available for download.)
3
Some typical installation Problems:
During testing, everything worked very well, but now …
Check the license of your ESXi host. If you have used an evaluation key for the ESXi host when setting it up, you may have
configured some commercial functions. If you then imported the free key, strange error messages suddenly appear or the host
no longer shuts down.
Also check whether you have entered the correct key in the RCCMD. Basically, the RCCMD appliance is equipped with an
evaluation key that can be changed at any time via the web interface. When the evaluation period has expired, RCCMD will stop
the service. If you enter an incorrect or invalid key, the evaluation phase is automatically activated.
Sometimes one RCCMD runs, then the other ,... …
This always happens if you have accidentally entered RCCMD keys several times. In this case, when the network starts, the first
RCCMD that starts with an affected key will claim it for itself. Subsequent RCCMD clients, however, will stop again with a
corresponding log entry “License fraud <IP address>.
Typical network problems, e.g. …
vLAN is in use:
Even if both hosts are on the same switch, because the ports are separated via vLAN, they must be seen as two separate
networks.
Portseparation and/or missing routing:
This configuration is quite common when servers are in different network segments and e.g. an uplink line to a neutral third
network segment with internet connection exists. The router requires special routing entries in order to be able to mediate
between the networks. Among other things, you can also set here that the RCCMD appliance can only reach the hosts
To Next Page
Loading...
