v.: 2020-09-04
Copyright of the European Union is effective (Copyright EU) (c) 2019 GENEREX Systems GmbH, Hamburg, Germany, All rights reserved
TEL +49(40)22692910 - EMAIL generex@generex.de - WEB www.generex.de (This and all other product datasheets are available for download.)
58
For safety reasons, RCCMD has no backdoors installed by default.
If you assign a new password to user admin, ensure it will be documented!
Otherwise you are damned to set up the complete RCCMD appliance again and reassemble all shutdown scripts. To prevent
this incident, it is recommended to set up a backup user to ensure resetting passwords.
After installing the appliance, it is possible to access the console with a freeware tool like Putty:
User: admin
Password: RCCMD
Requesting root privileges
Command: sudo su
Note the user "admin" not yet has been granted the
necessary rights to set up a corresponding emergency
user. This command will enable the superuser for
advanced rights
Creating user and password
This step requires two commands
Command 1: useradd <Username>
This command will deploy a new user.
Command 2: passwd <Username>
This command sets up a valid password.
Adding to administrative user group
Command: usermod – G sudo -a Emergency
In order for the newly created user to be granted the necessary rights, he must be assigned to the appropriate user group
Logging off
Command: exit
Note: Enter exit twice:
The first exit will close up the SuperUser, the second exit
will quit the connection to RCCMD and clos the console.
To Next Page
Loading...
