Version: 2020-09-04
58
Copyright of the European Union is effective (Copyright EU) (c) 2019 GENEREX Systems GmbH, Hamburg, Germany, All rights reserved
TEL +49(40)22692910 - EMAIL generex@generex.de - WEB www.generex.de (This and all other product datasheets are available for download.)
UPS Configuration
General COM Port setting
For this configuration step, navigate to the following menu:
Depending on the design and model, the CS141 provides up to three additional COM ports fulfilling different functions. Please note in
some cases submenus will appear to specify functions of devices connected to CS141. To start configuration, go to Devices and press
Setup.
Ensure UPS is selected at COM 1:
As a standard, COM1 the setting UPS should be selected. If not, open the drop-down menu
and select UPS.
By pressing Apply this selection will be saved and the CS141 will start required services to
communicate with the UPS:
Keep in mind by activating this function, a dummy is set first - this is necessary to allow a
general access to the corresponding submenus.
The CS141 will display the current starting phase as well as the success of the activation at the upper task bar.
➔ UPS service start up routine in progress
➔ The UPS feature finished booting, the UPS
menu accessible
Please note that only a dummy without a function has been started at this point, even if a UPS is apparently connected and in operation:
To Next Page
Loading...
