Version: 2020-09-04
69
Copyright of the European Union is effective (Copyright EU) (c) 2019 GENEREX Systems GmbH, Hamburg, Germany, All rights reserved
TEL +49(40)22692910 - EMAIL generex@generex.de - WEB www.generex.de (This and all other product datasheets are available for download.)
➔ Test an existing job
Symbols providing two functions:
➔ delete
➔ Checkbox to select multiple jobs or events
➔ Add a job
Note:
Dual function symbols have two different meanings:
Depending on where you serve them, they refer to ALL events or to a specific event or job. This dual functionality allows you to add a
specific event to specific or all system events without the need of entering each job individually.
Setting up a job
Managing jobs for a system event always follows the same rules - as an example, the following system events are selected:
Select > to open the job table:
For the event Power failure, a total of 3 jobs are already configured. These jobs were loaded as a recommended default configuration
when selecting a UPS. To change or remove, just click on the corresponding icon.
The CS141 allows to delete all jobs within a system event:
By doing so, activate the checkbox in the line for power
failure and press the symbol for deleting events. After
pressing all jobs associated with this one event will be
deleted from the list.
Note:
Deleted jobs cannot be retrieved, they must be recreated or restored by using a backup. To prevent accidental deletion, administrators
will be prompted to confirm their decision to delete all entries inside an event...
To add a job to the power failure event, press + at the event line. This will trigger the configuration dialog who will guide you through
configuration process.
To Next Page
Loading...
