Generic SFR1M44-U100 User Manual

SFR1M44-U100
User manual
Floppy to USB emulator
Model:
SFR1M44-U100 code*
：
U00 142
Floppy driver with below function needed:

Floppy driver with 34pin interface, and 5V DC power plug (example: SONY YE-DATA
ALPS TEAC EPSON PANASONIC NEC )


Use 2HD floppy disk with 1.44MB capacity
Format of disk : Cylinders: 80
Tracks: 160
Sectors/Track: 18 Bytes/Sector: 512 Data
transfer rate: 500 kbps Encoding method: MFM.
Features:



Use normal USB flash drive as the medium for transfer design.
34pin floppy driver interface, 5V DC power supply, easy to install.
Capacity: 1.44MB 2HD Cylinders: 80 Tracks: 160 Sectors/Track: 18 Bytes/Sector: 512 Data
transfer rate: 500 kbps Encoding method: MFM.


1000pcs partitions in USB flash drive can be used.
Built-in self-format function. (read relevant documents to use this function)
Panel:
8segment numbers: represent partitions number
Green led: status of read and write operation
USB port: connect USB flash drive
Button:
Left button used to rise ten-digit, right button used to rise single-digit, press 2 button together to
rise hundred-digit.
Operation :
 Format USB flash drive.
1.
2.
use built-in self-format function to format USB flash drive into 1000pcs partitions.
use software in CD format USB flash drive under WINDOWS XP/2000, into 000-099 100pcs
partitions.
3.
install an emulator on computer, and format every partitions by operate driver A:.
Version 140616
GOTEK emulator

Generic SFR1M44-U100 Specifications

General

Model	SFR1M44-U100
Category	Computer Hardware
Interface	USB
Data Storage	USB Flash Drive
Floppy Drive Interface	34-pin floppy drive interface
Capacity	1.44MB
Storage Temperature	-20°C to 60°C
Device Type	USB Floppy Drive Emulator

Summary

Floppy Driver Requirements

Emulator Features

Panel Overview

Panel Components

Details on 8-segment numbers, green LED status, USB port, and button functions.

Emulator Operation

Format USB Flash Drive

Guides on formatting the USB flash drive using built-in function, software, or by operating driver A:.

Read and Write Data

Steps for reading and writing data via the emulator on a machine or computer.

Jumper Settings

Firmware and Error Information

Firmware Version

Procedure to display emulator firmware version and detect different models.

Error Codes

Explanation of common error codes E0 and E16 encountered during operation.