EasyManuals Logo

Genesis 6.1e User Manual

Genesis 6.1e
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
ver 1.0
33
absolute fidelity
1 A Quick Start Set-up Guide
Now that you have your new Genesis 6.1e loudspeaker system, we
realize that you can’t wait to hook it up and start playing! However,
please read this quick set-up guide (even if your dealer is setting it up for
you) before you proceed.
1.1 Unpacking
Your loudspeakers will come to you in two large shipping cartons. The
cartons containing your speakers weigh over 90lbs (41kgs) each, so we
suggest a minimum of two strong people to move the speaker cartons
around. We will not be held liable for damage to either the speakers or
your backs during unpacking and setting up.
The packaging is designed to ship the speakers vertically, and to be
unpacked horizontally. Please observe the “This Side Up” signs when
shipping and unpacking.
The carton is designed to unfold to make it easy to remove the
speakers. With a sharp knife, cut the tape on the top and two ends of
the carton. The sides will fall apart revealing the speaker held in place by
a back support box, and two pieces of foam holding on to the top and
bottom of the speaker. You will also find the wire grill that will go on the
front of the speaker.
Remove the foam on the bottom of the speakers, and slide the plastic
and foam wrapping off. Now, tilt up the speaker until it is resting on its
bottom. Remove the top piece of foam, and the wrapping. Repeat with
the other speaker, and store the packaging in a dry, safe place just in
case you need to transport the speakers.
1.2 Room Placement
A good starting position for your G6.1e is about 18 inches (46cm) into
the room as measured from the front wall (the wall you look at as you
are seated listening to the speakers) to the back of the base of the
speakers. Place the speakers about five to six feet (1.8 metres) apart
measured between the tweeters. Toe the speakers in slightly towards
the listeners by about 5 to 10 degrees no more.
This is the best starting point for audiophile two channel stereo set-ups.
If you are primarily using these speakers for home theatre enjoyment,
the speakers can be placed nearer to the wall. If you are only going to
use these speakers for stereo, you may want to pull them further away
from the wall.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Genesis 6.1e and is the answer not in the manual?

Genesis 6.1e Specifications

Frequency and Sensitivity IconFrequency and Sensitivity
frequency response48Hz to 36kHz, +/- 3dB
sensitivity89 dB 1 watt 1 meter
Power IconPower
minimum power (tube)75 watts per side
maximum power (tube)500 watts per side
minimum power (solid state)100 watts per side
maximum power (solid state)1000 watts per side
Impedance IconImpedance
high level input impedance4 ohms (Nominal)
Transducers IconTransducers
HF transducersTwo Genesis 1” Circular Ribbon Tweeters
midrange transducersOne Genesis 5 “ titanium cone midrange
bass transducersTwo Genesis 6.5” aluminium cone
Weight and Dimensions IconWeight and Dimensions
height41 ¾ ”
width10 ¼ ”
depth14”
weight79 lbs (36kg) per side

Related product manuals