4.6 Lifting
●Please use four or more soft lifting belts to move the sets (see Figure 6).
●Please use protective plates on the surface of the units when handling to avoid scratches and
deformation.
●Double-check that the support base is strong enough before fixing the unit.
● The heat pump will produce condensation water: remember to provide a drainage channel when
making the installation base.
●Please install shock absorbers on the surface of the base.
Figure 6 Lifting diagram
5.1 Attention
● Prevent air, dust and other material from going into the water pipes.
● Fix the whole system before installing the water pipes.
● Water inlet and outlet pipes should be protected by an insulation layer.
● Make sure that there is a stable water flow, to prevent excessive throttling.
● Do not handle, move or lift the unit by holding the water inlet and outlet pipe: use only the holes on
the beam of the base (see Figure 9)
● When connecting the water inlet and outlet pipes, use two pipe wrenches to adjust the two parts of
the pipes, and make sure the water inlet and outlet pipes do not twist (see Figure 7).
To Next Page
Loading...
Need help?
General
