Genesis G70 - Page 21

DRIVING
Quick Reference Guide I 36
35 I Quick Reference Guide
GENESIS G70
SMART CRUISE CONTROL
Setting vehicle distance
(SMART CRUISE CONTROL only)
The vehicle to vehicle distance will
automatically activate when you set
the cruise speed.
This system assist you in setting the
distance from the vehicle ahead and
will maintain the selected distance
without you depressing the accelerator
or the brake pedal.
However, in stop and go traffic if the
vehicle stops for more than 3 seconds,
you must depress the accelerator pedal
or push the toggle switch to start driving.
Each time the vehicle distance
set button is pressed, the
vehicle to vehicle distance
changes as follows:
AIRBAG
GENESIS
MODE
AIRBAG
GENESIS
MODE
The cruise control system allows
you to program the vehicle to
maintain a constant speed without
holding the accelerator pedal.
1
To turn On/Off cruise control.
2
Toggle switch UP to Resume or
Increase the cruise control speed.
3
Toggle switch DOWN to Set or
Decrease the cruise control
speed.
4
To temporary cancel the Cruise
Control
5
To set the vehicle distance
Distance 2
Distance 3Distance 4
Distance 1
Setting Cruise Control
1. Press the “CRUISE” button
1
to turn on Cruise Control. The icon
will illuminate in the instrument cluster.
2. Toggle “-SET” switch
3
DOWN to set cruising speed.
Adjusting the vehicle speed
1. Toggle “+RES” switch
2
UP to increase cruising speed.
2. Toggle “-SET” switch
3
DOWN to decrease cruising speed.
NOTE: Quick toggle up/down will change speed by 1 mph.
Holding switch up/down will change speed by 5 mph.
To Cancel Cruise Control
Press the “PAUSE ” button
4
to temporarily cancel SCC. To
turn off Smart Cruise Control, press the Driving Assist
1
button and
SCC will turn off.
AIRBAG
GENESIS
MODE
2
3
4
5
1
AIRBAG
GENESIS
MODE