5-94
Driving your vehicle
LDWS operation
To activate the LDWS:
With the ignition switch in the ON
position, press the LDWS button
located on the instrument panel on
the lower left hand side of the driver.
The indicator in the cluster display
will initially illuminate white. This indi-
cates the LDWS is in the READY but
NOT ENABLED state.
Note that the vehicle speed must be
at least approximately 60 km/h (38
mph) to ENABLE the LDWS. The
indicator in the cluster display will
illuminate green.
If your vehicle speed exceeds 60
km/h (38 mph) and the LDWS button
is ON, the system is enabled. If your
vehicle departs from the projected
lane in front of you, the LDWS oper-
ates as follows:
OHI056075L
OHI056137L
OHI056136L
■ Lane line detected
■ Lane line undetected
To Next Page
Loading...
