Genesis G90 2017 - Page 459

7-73
07
Headlamp low beam (LHD side)
1. Turn the low beam on without driver aboard.
2. The cut-off line should be projected in the cut-off line shown in the picture.
3. When aiming the low beam, vertical aiming should be adjusted after adjust-
ing the horizontal aiming.
4. If headlamp leveling device is equipped, adjust the head lamp leveling
device switch with 0 positions.
GROUND
H1(Low beam)
CAR axis
Vertical line of the right head lamp bulb center
Horizontal line of head lamp bulb cente
r
Vertical line of the left head lamp bulb center
CUT-OFF LINE
W1(Low beam)
OHI076064L
■ Based on 10m screen