Genesis GMT25T - Knowing Your Oscillating Tool; Tool Components Identification

English
Multi-Purpose Oscillating Tool
Operator’s Manual GMT25T
• Do not wet-sand with this tool. Water or moisture entering the motor housing can cause
electric shock and serious personal injury.
•
Always be sure that the tool is switched off and unplugged before adjusting, adding
accessories, or checking a function on the tool.
WARNING: Read and understand all warnings, cautions and operating
instructions before using this equipment. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious personal injury.
SAVE THESE INSTRUCTIONS
KNOWING YOUR OSCILLATING TOOL
1. ON/OFF Switch
2. Variable Speed Dial
3. Accessory Quick-Change Lever
4. Flanges
5. Bi-Metal Flush Cut Blade 1-3/8”
6. Rigid Scraper Blade
7. Coarse Tooth Flush Cut Blade 1-3/4"
8. Segmented Saw Blade 3-1/8"
9. Delta Hook & Loop Sanding Pad 3-1/8"
10. Sandpaper Assortment
11. Storage Case
1
2
3
4
9
5
10
11
10
8
7
6
FIG 1