Quick Reference Guide I 20
GENESIS ELECTRIFIED GV70
INFOTAINMENT
19 I Quick Reference Guide
SHIFT BY WIRE (Electronic type shifter)
To shift the gear to P (Park), press
the P button while depressing the
brake pedal.
To shift the gear to N (Neutral), rotate
the shift dial clockwise from R
(Reverse) or counterclockwise from
D (Drive) while depressing the brake
pedal.
To shift the gear to R (Rear), rotate
the shift dial counterclockwise while
depressing the brake pedal.
A
B
C
A
Rotary shifter (Rotary gear
shift dial),
B
Park button,
C
P
Release Cap
Opening the charging door
CHARGING DOOR
1. Depress the brake pedal and apply the parking brake.
2. Turn OFF all switches, shift to P (Park), and turn OFF the vehicle.
3. Push the charging door where the tringle symbol
1
is located to
open. The charging door opens only when the vehicle is unlocked.
4. Open the inlet cover
2
.
i
Information
If you cannot open the charging door due to freezing weather, tap lightly
or remove any ice near the charging door. Do not try to forcibly open the
charging door.
DRIVING
NOTICE: HomeLink
®
operates while the ignition switch is in the ACC
or ON position for safety reasons. It is to prevent unintentional security
problems from happening when the vehicle is parked outside the garage.
Rolling Code Programming
•You may need a ladder to access your garage door opener.
•You may need help from a second person.
•Be prepared some of the steps are time sensitive.
1. Firmly press and release the “Learn”, Smart”, or “ Program” button
of garage door opener on the ceiling while the indicator
7
flashes
in Green. Once the button is pressed, you have approximately 30
seconds to initiate the next step.
2. Return to the vehicle and firmly press the HomeLink button, hold for
two seconds and release the button up to three times. Do not press
the HomeLink button rapidly. At this point programming is complete
and your device should operate.
For more detailed information, please refer to your Owner’s manual or
visit www.homelink.com or call (800) 355-3515
NOTE:
If your garage door opener has Two-Way Communication
functionality, it is possible for HomeLink to stop functioning the garage
door shortly after initial programming, if the Two-Way Communication
Programming wasn’t properly completed. If you experience this,
completing the “Programming a New HomeLink Button” and “Two-
Way Communication Programming” will restore door operation.
To Next Page
Loading...
Need help?
General
