Geneva Cinema - Page 6

4
AUDIO
Total Volume and Voice Enhancement improve your audio experience in TV mode. These functions are not supported in Bluetooth or Line-in.
Total Volume
TM
Press to turn the Total Volume function on and off. dbx-tv
®
Total
Volume is a patented audio technology which ensures an enjoyable TV
viewing experience free from jarring loudness variations caused by:
• Loud commercials: The loudness of many commercials is typically
higher than the regular TV program. With Total Volume enabled you
don’t need to adjust the TV volume before and after commercials.
• Movies: The audio track on a DVD or Blu-ray is produced for
movie theaters. The loudness differences between quiet and loud
passages can be extreme. Total Volume balances those differences
so you do not need to adjust the volume during while watching the
movie.
• Nighttime TV watching: Quiet conversations can be difficult to
understand when watching TV at lower levels, and loud sound
effects can disturb the neighbors. Total Volume elevates quiet
speech and keeps loud passages close to the program’s average
loudness, so it is not necessary to adjust the TV volume.
Voice Enhancement
The feature helps you better understand conversations. Press
to
turn this function on and off.
Bass and treble
Use and on the Model Cinema remote control to adjust
bass and treble.
TV
Normal operation
Once you have connected the TV to the Model Cinema, you can start
operating the Model Cinema. Since the Model Cinema turns itself
automatically on and off, you only need to adjust the audio settings
( volume, bass, treble, Total Volume, Voice Enhancement ).
Press TV on the remote control to listen to audio from the TV.
Changing the volume
There are a few ways to control the volume:
• Using the volume control of your TV set-top box or satellite receiver.
In this case, select a reasonable maximum volume via the Model
Cinema remote control, then use the set-top box remote control.
• Use the volume controls of the Model Cinema remote control.
• Use the volume controls above the display.
Automatic Power -On
If your TV is turned on, the Model Cinema will automatically power
itself on, as soon as there is an audio signal on one of the three TV
inputs connectors.
Automatic Power -Off
The Model Cinema will automatically turn itself off after 15 minutes if
there is no active Bluetooth connection, or if there is no audio signal at
the TV inputs or the Line-in connectors.
Automatic selection of the TV audio input
The Model Cinema automatically selects the correct audio input from
the three different TV audio inputs ( analog, coaxial and optical ).
Manual selection of the TV audio input
If you press and hold for a few seconds, you can select the
three different TV inputs manually. If you hold the key for 3
seconds, the automatic selection is turned on again. If the automatic TV
input selection is disabled, then the automatic power-on function is also
disabled.