DIP SWITCH / FIXED CODE PROGRAMMING
Step 1: Record Switch Positions
▪ Each shaded box below represents a switch position. In these boxes, write in the number 1,
2 or 4 as it corresponds to the +, 0, or – switch position shown on the remote, opener or
receiver. If you have less than 12 switches, only fill in what you have. You will reference this
section in STEP 3.4 below.
Step 2: Determine Specifications
▪ Find your specification from CHART B below and record the number here:
This box should have one number between 1-8. You will reference this in STEP 3.9 below.
Available in remotes with software REVs v1.1.4 and higher
If the opener has a group of switches with 3 positions per switch (TRINARY):
▪ Switch in the UP (+) position = press button 1
▪ Switch in the MIDDLE (0) position = press button 2
▪ Switch in the DOWN (-) position = press button 4
In this example, the code would be:
If the opener has a group of switches with 2 positions per switch (BINARY):
▪ Switch in the UP (+) position = press button 1
▪ Switch in the DOWN (-) position = press button 4
In this example, the code would be:
To Next Page
Loading...
