Genie Universal 4-Button - Programming

Page 3
Step 3: Programming
ENTER LEARN MODE:
1. On the universal remote, press and hold down button #1.
2. While still holding down button #1, press button #4 on the universal remote four
times.
3. Release both buttons - The WHITE LED on the remote will quickly flash 4 times.
ENTER DIP SWITCHES:
4. On the universal remote, enter in order the numbers 1, 2 or 4 as you have written in
STEP 1. The LED lights with each button press.
5. After the last DIP switch position entry, simply wait for the BLUE LED to quickly flash
4 times and go out.
ENTER BUTTON SELECTION MODE:
6. On the universal remote, press and hold down button #2.
7. While still holding down button #2, press button #3 on the universal remote four
times.
8. Release both buttons - the BLUE LED on the remote will begin flashing.
9. Press the button of your choice on the universal remote the required number of
times indicated from Chart B in STEP 2 above. You will have 10 seconds to complete
your entry.
10. After your press(es), simply wait the remainder of the 10 seconds - the BLUE LED will
give a long blink and then go out.