To Next Page
U
uhollowayJul 30, 2025
Why does my Genius Digital Camera LCD display “memory full”?
- BbeckandreaJul 30, 2025
If your Genius Digital Camera's LCD displays “memory full”, this indicates that both the camera memory and the SD card are full.
Why does my Genius Digital Camera LCD display “memory full”?
If your Genius Digital Camera's LCD displays “memory full”, this indicates that both the camera memory and the SD card are full.
Why does my Genius Digital Camera take blur shots?
If your Genius Digital Camera is producing blurry shots, try the following: * Check MCU board SW6 for cold soldering or breakage, which can cause switching failures between distant and close shots. * Inspect the lens for dirt. * Verify that the lens is neither loose nor malfunctioning.
How to troubleshoot TFT-LCD no image/noise on Genius Digital Camera?
If the TFT-LCD on your Genius Digital Camera shows no image or displays noise, consider these checks: * Verify that the LCD soft board is securely connected to the interface. * Check JP3 for cold soldering. * Confirm that the LCD is functional. * Ensure that the signal DRV has a square wave output and that LED ANDOE is approximately 7V.
Why does Genius Digital Camera fail to UPDATE?
If your Genius Digital Camera is failing to update, check if the SD base has cold soldering and ensure the SD card contains the correct program with the correct name.
Why is my Genius Digital Camera charging is normal but no triggering?
If your Genius Digital Camera is charging normally but not triggering, check the following: * Verify the Flash Mode setting is correct. * Check the reflector's lead wire for cold soldering or broken circuits. * Inspect C6 and C7 for cold soldering or broken circuits. * Check interface JP3 for cold soldering. * Examine the tube for cold soldering, offset, cracks, or broken circuits. * Confirm that Q3 and Q5 are OK.
Why does my Genius Digital Camera experience charging fail or insufficient charging voltage?
If your Genius Digital Camera is experiencing charging failure or insufficient charging voltage, check the following: * Verify if Trigger/B IGBT Q2 is breakdown. * Check if D3 is been reverse breakdown. * Inspect if R1/R2/R4 is cold soldering, value changed. * Check if U1 is cold soldering or NG. * Check if the big capacitor has leakage.
General| Sensor Size | 1/2.5 inch |
|---|---|
| Effective Pixels | 6.0 Mega Pixels |
| Maximum Resolution | 2816 x 2112 |
| Optical Zoom | 3x |
| Digital Zoom | 4x |
| LCD Monitor Size | 2.4 inch |
| Display | TFT LCD |
| Video Resolution | 640 x 480 |
| Lens | f=6.2 - 18.6 mm |
| Storage | SD card |
| Connectivity | USB |
