GENPOWER FORTRUST 6110D User Manual

6. PARAMETER SETTING:
No
Parameter
Range
Default
Description
1
Mains Normal Delay
(0-3600)s
10
The delay from abnormal to normal or from normal to
abnormal. It is used for ATS (Automatic Transfer Switch)
control.
2
Mains Abnormal Delay
(0-3600)s
5
3
Mains Under Voltage
(30-60000)
V
18
When mains voltage is lower the value, mains under
voltage is active.
4
Mains Over Voltage
(30-60000)
V
276
When mains voltage is higher than the value, mains over
voltage is active.
5
Transfer Delay
(0-99.9)s
1.0
It’s the delay from mains’ breaker open to generator’s
breaker closed or from generator’s breaker open to mains’
breaker closed.
6(1)
Start Delay
(0-3600)s
1
When mains abnormal or remote start signal is active this is
the delay time of starting genset.
7(2)
Stop Delay
(0-3600)s
1
When mains normal or remote start signal is inactive this is
the delay time of stopping genset.
8(3)
Start Times
(1-10)
3
This is the number of cranking. If engine has a start failure,
genset cranks as set value times. When cranking times
finish, controller sends start fail signal.
9(4)
Preheat Delay
(0-300)s
0
Time of pre-powering heat plug before crank is powered
up.
10(5)
Cranking Time
(3-60)s
8
Time length of cranking time.
11(6)
Crank Rest Time
(3-60)s
10
When engine has a start fail it is the waiting time between
crankings.
12(7)
Safety On Time
(1-60)s
10
Alarm for low oil pressure, high tempareture, under speed,
under frequency/ voltage, failed to charge are all checked
within this time, if it continues alarm would rise.
13(8)
Start Idle Time
(0-3600)s
0
It is the idle running time of genset while starting.
14(9)
Warming-up Time
(0-3600)s
10
It is the warming time between genset switch on and high
speed running.
15(10)
Cooling Time
(3-3600)s
10
It is the time for cooling before genset stopping.
16(11)
Stop Idle Time
(0-3600)s
0
It is the idle running time while genset stopping.

GENPOWER FORTRUST 6110D Specifications

General

Brand	GENPOWER
Model	FORTRUST 6110D
Category	Controller
Language	English