EasyManua.ls Logo

Gentech GP3500i - Pre-Operation Inspection; Engine Oil Inspection and Requirements; Fueling Safety Precautions; General Operational Safety Tips

Gentech GP3500i
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
5. PRE-OPERATING INSPECTION:
5.1 Engine Oil This is a major factor affecting the performance and life
span of the Generator. Do not use non-detergent and 2 stroke oil as
this will damage the Generator.
5.2 Before using the Generator check the oil level, ensure that the unit is
on a flat and level surface when doing this and that the unit is “OFF”
5.3 The recommended oil to use is 4 stroke gasoline engine oil IE
SAE10W-30
5.4 Running the Generator with insufficient engine oil will cause damage
to the Generator.
5.5 Please note that the Generator is fitted with a “low oil alert sensor”.
5.6 Only use clean un-leaded fuel when operating/running the
Generator
. Dirty/contaminated fuel will cause damage to the
Generator and will affect the performance.
5.7 Gasoline is extremely flammable, exercise extreme caution when
putting fuel into the fuel tank. DO NOT BE NEGLIGENT.
5.8 Always refuel in a well-ventilated area.
5.9 Do not attempt to refuel the Generator whilst the engine is running.
5.10 Be careful not to over fill the tank when refueling. If this happens,
clean the fuel spillage properly.
5.11 Do not smoke whilst refueling.
5.12 Keep out of reach of children