22
To prolong the life of your generator and attached devices,
follow these steps to add an electrical load
:
8.2.1 Start the generator with no electrical load attached.
8.2.2 Allow the engine to run for several minutes to stabilize.
8.2.3 Plug in and turn on the first item, it is best to attach the item
with the largest load first.
8.2.4 Allow the generator to stabilize.
8.2.5 Plug in and turn on the next item.
8.2.6 Repeat steps 5-6 for each additional item.
8.3 CONNECTING ELECTRICAL LOADS:
8.3.1 Let the engine stabilize and warm up a few minutes after
starting.
8.3.2 Prior to powering tools and equipment make sure that the
generators rated voltage, and amperage capacity is
adequate to supply all the electrical loads that the generator
will power. (230V,7amps,12V DC @ 8 Amps)
8.3.3 Once the generator is running, simply connect the [power
cords of 230V AC equipment into the AC outlets.
8.3.4 DO NOT connect 3-phase loads to the generator.
8.3.5 DO NOT overload the generator.
To Next Page
Loading...