EasyManua.ls Logo

GENUINE DGH9 V4 080 User Manual

GENUINE DGH9 V4 080
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
GENUINE REAR BUMPER GUARD
INSTALLATION AND USER’S INSTRUCTIONS
PART NAME: REAR BUMPER GUARD
PART NUMBERS: DGH9 V4 080
VEHICLES: MAZDA CX-30
To the dealer
• Please turn over these instructions to the customer after installation.
To the dealer
• Keep these instructions after installation. The instructions may be necessary for installing other
optional parts or removal of this accessary.
• Should the vehicle or this accessory be resold, always transfer these instructions to the next
owner.
Thank you for purchasing a Genuine Mazda Accessory.
Before removal and installation, please thoroughly read these instructions.
For your safety, please read the contents of this booklet to properly install and use the bumper guard kit.
Keep these instructions with your vehicle records for future reference.
• There are several
the rear bumper guard. Always read and follow the instructions in order to prevent injuries, accidents, and possible
damage to the vehicle.
Do not modify the rear bumper guard.
Do not install the rear bumper guard in any way other than described in the following instructions.
• If in doubt, please contact your Mazda dealer to install the accessory in order to prevent errors in installation.
• If you have any questions about the use of the accessory, ask your Mazda dealer for proper advice before using it.
• Mazda and its suppliers are not responsible for injuries, accidents, and damage to persons and property that arises from
the failure of the dealer or installer to follow these instructions.
• To ensure safety and reliability of the work, installation, removal and disposal work must be carried out by an Authorised
Mazda Dealership.
• Be careful not to lose removed parts, and be sure that they are kept free of dirt, scratches, or damage.
WARNING and CAUTION sections in this booklet concerning safety when installing
WARNING: Indicates a situation in which serious injury or death could result if the warning is
ignored.
CAUTION: Indicates a situation in which bodily injury or damage to the vehicle could result if the
caution is ignored.
WARNING
MAZDA MOTOR CORPORATION
Hiroshima Head Office 3-1 shinci, Fuchu-cho, Aki-gun, Hiroshima 730-8670
201903
NOTE
SK713
Page 1/18
Question and Answer IconNeed help?

Do you have a question about the GENUINE DGH9 V4 080 and is the answer not in the manual?

GENUINE DGH9 V4 080 Specifications

General IconGeneral
BrandGENUINE
ModelDGH9 V4 080
CategoryAutomobile Accessories
LanguageEnglish

Summary

Genuine Mazda Rear Bumper Guard Installation

Safety Warnings and General Precautions

Read all warnings and cautions to prevent injury, accidents, and vehicle damage during installation.

Pre-Installation Preparation Steps

Ensure vehicle is at room temperature, clean and dry the installation area thoroughly.

Prepare Vehicle Bumper for Installation

Clean bumper surfaces, apply adhesion promoter, and prepare for template placement.

Position Side Installation Templates

Fold and align die-cut templates to the rear bumper using alignment holes.

Prepare Rear Bumper Guard Adhesion

Peel and fold backing tape liners from the bumper guard sections.

Trial Fit Rear Bumper Guard

Align the bumper guard with the trunk latch and templates to check fitment.

Apply Pressure and Finalize Installation

Use a rubber roller to ensure proper adhesive bond and wipe the area clean.

Post-Installation Inspection Checklist

Inspect installed parts for fit, scratches, dirt, engagement, and proper operation.