71
English
• Anchor Alarm (OFF/15m/
30m/50m)
Enables/disables the alarm
and sets the distance range
for the anchor alarm.
• Compass Calibration (ON/
OFF)
Sets the compass to obtain a
current position as accurate as
possible.
• Set altitude (ON/OFF)
Sets the altitude value used by the barometer.
COMPASS CALIBRATION
To set the compass, proceed as follows:
• Keep the unit horizontal, and turn it slowly at least two
turns, until a confirmation message is issued.
• Orientate the unit towards the north and then turn it slowly
around the longitudinal axis until a confirmation message
is issued.
3S
To Next Page
Loading...
