GENERAL MAINTENANCE
Page 5
Inspect ion of fan at least once every 12 months is recommended to ensure that the motor, fan
blades, and supporting guards, are clean. Any build up of dust and deposits on the blades guards
should be removed using a non-abrasive cleaner.
All fastenings should be checked for tightness. In addition, all rotating items should be checked.
Bearings are lubricated for life and will not need a detailed inspection.
WARNING The fan is fitted with an auto-reset thermal contact which switches the fan off in the
event of a fault condition. Once the motor cools down the fan may start unexpectedly. Only a
suitably qualified and competent person may carry out maintenance after the electrical supply
has been isolated
TECHNICAL DATA
BS Plug Wiring
Wiring Instructions: Should it be necessary to change the plug
please note the wires in the mains lead are coloured in accordance
with the following code:
BLUE ‐NEUTRAL
BROWN ‐LIVE
GREEN AND YELLOW ‐EARTH
As the colours of the wires in the mains lead of this appliance may
not correspond with the coloured markings identifying the terminals
in your plug, proceed as follows:
1. The BLUE wire is the NEUTRAL and must be connected to the
terminal that is marked with the letter N or coloured BLACK.
2. The BROWN wire is the LIVE and must be connected to the
terminal that is marked with the letter L or coloured RED.
3. Neither wire is to be connected to the terminal which is marked
with the letter E or earth symbol, coloured GREEN or
GREEN/YELLOW.
4. Always ensure that the cord grip is positioned and fastened
correctly. If a 13A(BS1363) fused plug is used it must be fitted with a
13A(BS1362) fuse. If in doubt consult a qualified electrician.
Wiringfora13Ampplug(BS1363)
The Earth Terminal is marked with the letter E or Earth Symbol
To Next Page
Loading...