GeoVision GV-R1352 User Manual

GV-Card Reader
Before attempting to connect or operate this product, please
read these instructions carefully and save this manual for future use.
User’s Manual
READER-D

GeoVision GV-R1352 Specifications

General

Brand	GeoVision
Model	GV-R1352
Category	Card Reader
Frequency	13.56 MHz
Ingress Protection	IP66
Supported Cards	MIFARE
Interface	Wiegand

Summary

GV-Reader1251 / 1352 V2 and GV-SR1251

Switch Setting of GV-Reader1251 / 1352 V2

Guide to dip switch configurations for Beeper, LED, and communication.

Defining the ID Number of GV-SR1251 by Using GV-Reader Config Utility

How to set the reader's ID number using software for GV-SR1251.

Connecting GV-AS Controller through Wiegand Interface

Wiring diagram for connecting GV-Reader to GV-AS Controller via Wiegand.

Connecting to GV-AS Controller through RS-485 Interface

Wiring and switch settings for RS-485 connection to GV-AS Controller.

Connecting to GV-DVR/NVR and Third-Party Access Controllers

GV-RK1352 / R1352 / DFR1352

Connecting the Reader to GV-AS Controller

Instructions for connecting readers to GV-AS Controllers via Wiegand or RS-485.

Connecting through Wiegand Interface

Wiring diagram for connecting GV-RK1352/GV-R1352 to GV-AS810 via Wiegand.

Connecting through RS-485 Interface

Wiring diagrams for connecting readers to GV-AS810 via RS-485.

Defining Readers on GV-AS Controller Web Interface

Installing GV-R/RK/DFR Config AP

Defining the ID Number and Setting the Reader to Slave

Wiring the Beeper and LED to GV-AS Controller

Firmware Upgrade

Instructions for updating the reader's firmware using the utility.

GV-RKD1352

Pin Definitions

Installation

Step-by-step guide for mounting the reader and connecting wires.