GeoVision GV-RK1352 User Manual

July 14, 2015 1
GV-RK1352 / R1352 / DFR1352 Card Reader
The content of this installation guide refers to the following readers:
• GV-RK1352 firmware V1.2
• GV-R1352 firmware V1.2
• GV-DFR1352 (Rev. B) firmware V1.2
Introduction
GV-RK1352 / R1352 / DFR1352 are card readers capable of recognizing identification cards.
GV-RK1352 comes with keypad, allowing it to also recognize PIN codes. GV-DFR1352 is
designed to be installed on the door frame.
Featured with the Wiegand and RS-485 outputs, the readers can be connected to any
standard access control panel. The readers are protected by a weather sealed and IP66
compliant housing for outdoor use.

GeoVision GV-RK1352 Specifications

General

Brand	GeoVision
Model	GV-RK1352
Type	Card Reader
Communication Interface	USB
Interface	USB 2.0
Operating System Compatibility	Windows, Linux
Ingress Protection	IP54
Supported Cards	Felica
Operating Humidity	10% to 90% RH
Power Supply	USB powered
Current Consumption	100 mA
Dimensions	90mm x 60mm x 15mm
Weight	150 g

Summary

Introduction

Packing List

Physical Descriptions

Electric Wire Details

Describes wire color and function for different reader models.

Keypad Operation (GV-RK1352 Only)

Explains PIN code entry and key functions for the RK1352 model.

LED Indicator and Beeper Behavior

Details standby and card read states, external control wires.

Connecting to GV-AS Controller

Wiegand Interface Connection

Diagrams and notes for connecting readers via Wiegand interface.

RS-485 Interface Connection

Diagrams and notes for connecting readers via RS-485 interface.

Defining Readers via Web Interface

Steps to define readers, assign serial numbers, and set functions on the web interface.

GV-R/RK/DFR Config AP Installation

GV-System Live View Integration

Defining Reader ID and Slave Mode

Steps to set reader ID and master/slave status using the Config AP.

Adding Readers to GV-System Software

Process for adding Wiegand capture devices within the GV-System software.

Beeper and LED Settings Configuration

Configuring Beeper/LED via Config AP

Enabling external control of reader beeper/LED using the Config AP.

Wiring Beeper/LED to GV-AS Controller

Wiring diagrams for connecting reader beeper and LEDs to GV-AS controller outputs.

Setting Beeper/LED Triggers per Door/Gate

Configuring alarm conditions to trigger beeper/LEDs via the controller's web interface.

Setting UID or GID Read Mode

Firmware Upgrade Procedure

Product Specifications

Supported Readers per GV-AS Controller

Table showing the number of readers supported by different GV-AS controller models.

Optional Accessories (GV-RK1352)

GV-MountA900 Mounting Plate

Details and installation of the mounting plate for the RK1352 reader.