July 14, 2015
10
3. Installing the GV-R/RK/DFR Config AP
The GV-R/RK/DFR Config AP allows you to set the reader’s beeper / LED, ID number,
master / slave status, and whether it reads UID or GID. When using the Config AP, the
reader needs to be connected to a PC through GV-COM, GV-Hub or GV-NET/IO Card V3.1.
You can install the Config AP from the Software DVD or GeoVision Website. To use a GV-
COM, GV-Hub or GV-NET/IO Card V3.1, you also need to install GeoVision USB Device
Driver.
Installing from Software CD
1. Insert the software CD and the Install Program window will pop up automatically.
2. Select Install GeoVision USB Device Driver.
3. In the GeoVision USB Driver Installer window that appears, select Install.
4. Go back to the Install Program window, and select Run GV-Reader Config Utility.
Downloading from GeoVision Website
1. Go to the Software Download and Upgrading page of GeoVision Website:
http://www.geovision.com.tw/english/5_8_AS.asp
2. Select GV-Reader from the drop-down list, and click the Download icon
of
GV-RK1352 & GV-R1352 & GV-DFR1352 Config Utility.
3. Select Driver from the drop-down list and click the Download icon of GV-
USB Device Driver.
To Next Page
Loading...
Need help?
General
