7. Firmware Upgrade
GeoVision will periodically release the updated firmware on the website. The new firmware
can be simply loaded into the reader by using Update Utility included in the Software CD.
Important Notes before You Start
Before you start updating the firmware, please read these important notes:
1. While the firmware is being updated, the power supply must not be interrupted.
2. Do not turn the power off within 10 minu after the firmware is updated.tes
WARNING: The interruption of power supply during updating causes not only update
failures but also damages to the device. In this case, please contact your sales
representative and send your device back to GeoVision for repair.
To upgrade firmware:
1. Insert the Software CD and select Run Firmware Update Utility. This dialog box
appears.
2. Select t
he COM port of the reader.
3. Click the Browse button to locate the firmware file (.bin)
saved at your local computer.
4. Click Update.
5.
The LED indicator should flash purple during the process of firmware upgrading. When
the process is complete, the reader will be sounded twice and the LED indicator will
change to green.
Note: You can also download the firmware upgrade utility from the GeoVision website:
http://www.geovision.com.tw/english/5_8_AS.asp. Under the Access Control tab, click the
Download icon of GV-RK1352 & GV-R1352 & GV-DFR1352 Firmware
Upgrade Utility.
December 31, 2014 19
To Next Page
Loading...
Need help?
General
