rmware.frm
x/xxxx/rmware.frm
PROGRAMMING
Please wait . . .
Menu
About...
Setup
Firmware
versions
CON 1
9 - Choose "Printer Firmware"
folder.
13 - The plotter display will show
a message about rmware being
installed. Wait until the plotter is
fully installed.
10 - Open the "rmware.frm" le
from the rmware release folder.
11 - Click on the "Set rmware"
button to install the program.
Do not turn off the plotter while
rmware update is in process.
Doing so may damage the main
board.
15 - Conect CON1.
14 - Once the process is nished,
please check the plotter version
on the plotter screen.
16 - Installation process is
completed. Turn off and on the
plotter and work normally.
12 - The display will show an
installation message. Click OK.
To Next Page
Loading...
Need help?
General
