Disposing of the equipment
Environmental damage may be cau
sed by
poisonous fluid residues.
Before disposing of the equipment
make sure that it is clean and free of
fluid residues.
For the disposal of all materials
observe the pertinent legal regulations
concerning waste disposal.
The equipment is made from the following
materials:
Materials for UNA 38
Flange, butt-weld end, socket weld end
Pipe weld end, flange (optional)
Set screws, sleeves and hex nuts
1 ASTM material is comparable to EN material. Note the differences in chemical and physical
properties.
Materials for UNA 39
Flange, butt-weld end, socket weld end, pipe weld end
Set screws, sleeves and hex nuts
To Next Page
Loading...