Operation
CONTROL PANEL
CONTROLS
Power Control
The power control turns the unit on and off.
When the plug is first plugged into a socket the machine will go into stand-by mode. Pressing the “Power” button will turn
the machine on. Pressing the “Power” button again will put the machine back into stand-by mode.
Warning Light
This warning light will illuminate (Red) when the water tank within the machine is full and the machine will
stop. If after draining the tank, the warning light remains on, this could indicate that there may be a fault
with the machine. If this is the case, do not attempt to operate the machine and call the service number.
Mode Control
The mode control has four settings Cool Dehumidifier Heating Fan
Repeated pressing of the mode button will select the modes in order as follows:-
Cool Mode - LED next to the “COOL” legend will illuminate green.
Dehumidifier Mode - LED next to DEHUMIDIFIER legend will illuminate orange.
Heating Mode - LED next to HEATING/FAN legend will illuminate red.
Fan Mode - LED next to HEATING/FAN legend will illuminate yellow.
Note:- In Cool, Heating and Fan modes, the fan speed can be set to High, Medium and Low. When
Dehumidifier mode is selected and the room temperature is below 25°C, the fan speed is automatically set to
medium and cannot be altered from this setting. When the room temperature is above 26°C the fan speed is
adjustable.
Cool Mode
In this mode the air is cooled and hot air is exhausted through the vent hose to outside the room. Fan speed
and temperature can be adjusted to suit the comfort level required.
Dehumidifier Mode
Air is dehumidified as it passes through the air conditioner and the damp warm air should be exhausted by
means of the vent hose to outside of the room.
Heating Mode
When heating mode is selected the indicator light will shine red. Heating is activated only when the ambient
temperature is below 27°C. Temperature setting range is 16°C to 27°C.
Fan Mode
Air is cooled and circulated throughout the room. Note:- It is not necessary for the vent hose to exhaust
outside the room.
Fan Speed
The fan speed can be set to high, medium or low. Note:- In dehumidifier mode , depending on the room
temperature, only medium fan speed is available. (See Note in Mode Control above).
To Next Page
Loading...
