Getac T800 - Using Manual

Using the
Using the Using the
Using the T800
T800T800
T800 M
MM
Magnetic
agnetic agnetic
agnetic S
SS
Stripe
tripetripe
tripe and Smart
and Smart and Smart
and Smart
Card Reader
Card ReaderCard Reader
Card Reader
Introduction
IntroductionIntroduction
Introduction
This snap-on module is a 2-in-1 card reader that can read:
 Smart cards
 Magnetic stripe cards
Hardware Installation
Hardware InstallationHardware Installation
Hardware Installation
1. Align the module with the back of T800, engage the module’s bottom
tab first and then snap the top tab into place.
2. Firmly press the connector area to ensure the connection. The module
has an icon indicating where to press.
3. Tighten four screws.