How to fix CM 100 XT, PhysioGate App Bluetooth pairing not possible?
If Bluetooth pairing is not possible and the device is not found on CM 100 XT with PhysioGate App, it means that Bluetooth on CM 100 XT is deactivated. Press and hold down the pushbutton on the CM 100 XT until a tune sounds and the LED flashes blue. Repeat the Bluetooth pairing.
How to solve CM 100 Configurator the ECG data could not be stored on the PC?
If the ECG data could not be stored on the PC when using CM 100 Configurator, it could be due to missing write access to download folder, the download folder no longer exists, or the hard disk is full. Check the download folder and create a new download folder if necessary. Repeat the download.
How to solve CM 100 Configurator the ECG report could not be created?
If the ECG report could not be created in CM 100 Configurator and you receive the error message 'Error! No PDF file created!', it indicates that the program installation is defective or damaged. Install the CM 100 Configurator anew. Repeat the download.
How to fix CM 100 Configurator data stored on the device cannot be deleted?
If the ECG data stored on the device cannot be deleted in CM 100 Configurator and you receive the error message 'Error! Data not deleted!', it suggests a communication error. Click on “Disconnect recorder” and then on “Connect to recorder” to reset the USB connection. If this does not function: Exit the CM 100 Configurator software. Remove the USB download cable (the device is turned off). Reconnect the USB download cable and restart the recorder. Start the CM 100 Configurator software. Click on “Connect to recorder” and repeat deleting.
General| Category | Measuring Instruments |
|---|---|
| Pacemaker detection | Yes |
| Data transmission | Bluetooth |
| Measurement Parameters | ECG |
| Connectivity | Bluetooth |
| Storage | SD Card |
| Measurement Types | ECG |
To Next Page
