Getinge 46-2 User Manual

7.1.1 Start condition list
Note!
If the Start condition for low detergent level appears in the
display, there was still enough detergent for the last run
cycle.
Start condition Cause Action
DOS 1 LOW
LEVEL
The detergent container 1 is empty. This condition is resolved automatically
when detergent is added. Refill detergent,
see section 6.2.2 Fill up with detergent.
DOS 2 LOW
LEVEL
The detergent container 2 is empty. This condition is resolved automatically
when detergent is added. Refill detergent,
see section 6.2.2 Fill up with detergent.
DOS 3 LOW
LEVEL
The detergent container 3 is empty. This condition is resolved automatically
when detergent is added. Refill detergent,
see section 6.2.2 Fill up with detergent.
DOS 4 LOW
LEVEL
The detergent container 4 is empty. This condition is resolved automatically
when detergent is added. Refill detergent,
see section 6.2.2 Fill up with detergent.
SELECT
PROGRAM
An invalid program has been selected. Select another program (P1-P20).
DOOR NOT
SEALED
The door is not closed. Close the door.
PRINTER
BUSY
Printout or downloading of the log is not
complete.
Wait until the task is completed.
MANUAL
MODE SET
A digital output port is set to manual
operation.
Reset output (possible via panel).
EXT COM.
NOT OK
No communication between PACS and
the NetCOM card.
Wait 60 sec. and try again.
If the error persists: Check that a USB stick
is connected to the detergent cabinet.
Check the cabling and settings.
PACS
BATTERY
LOW
Displayed when the control system's
backup battery is about to run out.
Contact service personnel.
SERVICE Displayed before start when it is time
for service (option).
Contact service personnel.
WAITING FOR
LOG
Displayed at the end of the process
while the log file is created if NetCOM
is installed (option).
Wait until the task is completed.
7 ALARM HANDLING
User Manual Getinge 46-series 41 (56)
<Doc_USR><Doc_6002267102><Rev.B><Lang_en>

Getinge 46-2 Specifications

General

Brand	Getinge
Model	46-2
Category	Washer
Language	English