Getinge 88-SERIES Technical Manual

<Doc_TEC><Doc_502406700><Rel_B><Lang_GB>
Page 4 of 148
Replacing a temperature sensor _________________________104
In wash chamber and dryer __________________________________ 104
In a booster tank __________________________________________ 104
Door ___________________________________________________105
Position and operation, door switches ________________________ 105
Adjusting door switches _____________________________________ 106
Adjusting DOOR UP safety switch ____________________________ 107
Replacing the door seal _____________________________________ 108
Removing the door _________________________________________ 109
Adjusting the door closing force ______________________________ 110
Adjusting the door frame ____________________________________ 110
Overheat protection _____________________________________111
Replacing the overheat protection in the booster tank ______________111
Replacing overheat protection in the main pipe ____________________111
Cleaning the water and steam valve ______________________112
Water valve ___________________________________________________112
Steam valve __________________________________________________112
Dryer ___________________________________________________113
Changing the filter __________________________________________ 113
Fan replacement and checking _______________________________ 113
Check valves to main pipe ___________________________________ 113
Conductivity measurement (extra equipment) _____________114
Function in washing process _________________________________ 114
Measuring range ___________________________________________ 114
Check the output signal from conductivity meter __________________114
Setting the cell constant ________________________________________114
To set the cell constant, proceed as follows: ______________________114
Replacing the main board _______________________________115
Replacing the expansion board __________________________116
Replacing fuses _________________________________________117
Electrically heated _____________________________________________117
Steam heated _________________________________________________118
Replacing a hose to a hose pump ________________________119
Setting detergent and rinse-aid quantities ________________120
Servicing the booster tank _______________________________121
Booster tank with drain tap __________________________________ 121
Overheat protection ________________________________________ 121
Process valve and diaphragm ____________________________122
Checking __________________________________________________ 122
Adjusting (adjustment allowances) ____________________________ 122
Repair ____________________________________________________ 122
Replacing the diaphragm ____________________________________ 122

Getinge 88-SERIES Specifications

General

Brand	Getinge
Model	88-SERIES
Category	Laboratory Equipment
Language	English