Gewiss RESTART RD GW 90 971 - User Instructions; Automatic Operation; Cutting in Automatic Mode; Automatic Restart

18
AUTOMATIC RESTART:
- In the case of a temporary fault
CUTTING IN AUTOMATIC MODE
230V
INSERIRE CON
LEVA IN
POSIZIONE I
ON OFF
0
I
230V
INSERIRE CON
LEVA IN
POSIZIONE I
ON OFF
TEST
I
Click!
Raise the lever.
(System powered up).
Slide the hatch until a click is heard (system
powered up).
I
230V
INSERIRE CON
LEVA IN
POSIZIONE I
ON OFF
TEST
I
0
230V
INSERIRE CON
LEVA IN
POSIZIONE I
ON OFF
TEST
0
1. Normal operation. 2. Differential switch cut-in.
0
230V
INSERIRE CON
LEVA IN
POSIZIONE I
ON OFF
TEST
0
I
230V
INSERIRE CON
LEVA IN
POSIZIONE I
ON OFF
TEST
I
3. The device performs a test of the system
of approx. 60sec. (Red indicator blinking).
Differential switch closing can be forced manually by going into manual mode and
raising the lever. Call the installation technician if the differential switch trips again.
*
*
4. Reset completed (the lever rises again,
powering up the system and cannot be
operated manually for the next 3 minutes).
AUTOMATIC OPERATION
USER INSTRUCTIONS