INSTALLATION OF THE CLEAN WATER TAp
Drill a 12 mm diameter hole in the sink.
Assemble the water tap in the following sequence:
faucet
decorative washer
rubber gasket
rubber washer
plastic washer
split washer
metal nut
31
А
2
В
!
FILTER INSTALLATION
It is recommended to install the lter with assistance of a qualied expert or a representative
of the manufacturer.
Do not disassemble the equipment without need.
PLEASE NOTE! Before you begin work, shut off the water supply and reduce the pressure
by opening any faucet below the shut-off position.
SETTING up THE FILTER
The system is attached to the cold water main.
Take out the lter from the packaging. Remove transport
plugs. Press the end of the screwdriver on the plastic ring in
the connector and pull out the plug. Cut the pipe provided in the
set into two parts, and attach each of the parts to the “in” and
“out” nozzles of the lter (g. 1). Place the lter in the location
convenient for further operation. To make cartridge replacement
more convenient, leave a 15 cm clearance between the floor and
the bottom of the lter body.
CONNECTION TO THE WATER SuppLY LINE
Make sure that the water supply line is shut off!
1. Install the adapter T-piece (A) on the cold water main, and
seal the junctions (g. 1)
2. Insert the plastic pipe into the nut (B) Install the pipe fully into the nozzle of the ball valve and
tighten the nut (g. 3)
1
To Next Page
Loading...
