GEZE E 260 N8/1 User Manual

grn
rot
rot blinkend
Notstrom
steuerzentrale
Em
ergency P
ow
er C
on
trol System
E 260 N
O
K
S
törung
N
etzausfall
O
K
Fault
Pow
er outage
grün
gelb
gelb blinkend
green
yellow
yellow flashing
Installation and Operating Manual
RWA-Emergency Power Control System
E260 N2/N4/N8/N12
GB
Id. No. 113959-04
DE Material-Nr. 104361 IT N. mat. 113961
FR N° de suite 113960

GEZE E 260 N8/1 Specifications

General

Brand	GEZE
Model	E 260 N8/1
Category	Control Systems
Language	English

Summary

Symbols and conventions

Danger and information symbols

Explains danger and warning symbols used in the manual.

1 Operation

1.1 Safety instructions for the operator and the user

Provides essential safety guidelines for operating the RWA system.

1.2 Overview of the RWA-Emergency Power Control System

1.2.1 The electrical components of the RWA-Emergency Power Control System

1.2.3 Components used in the case of alarm

RWA switch

Describes the RWA switch and its signal lamps for alarm status.

1.4 Fire alarm

Triggering the fire alarm

Outlines the methods for manually triggering a fire alarm.

Procedures and signals during the fire alarm

Describes system actions and signals during a fire alarm event.

Stopping the fire alarm

Resetting the system fully

Details the steps for a complete system reset after an alarm.

Resetting an RWA switch

Explains how to reset an individual RWA switch.

Reset the RWA-Emergency Power Control System

Checking the reset

Describes how to verify that the system reset was successful.

1.5 Power outage and fault

Power outage

Details system behavior and limitations during a power outage.

Fault conditions

Describes fault conditions and necessary actions.

2 Installation and maintenance

2.1 Safety instructions for installation and maintenance

Provides essential safety guidelines for installation and maintenance.

RWA-Emergency Power Control System

2.4 Connection options and configurations

2.4.1 Alarm group

Setting the direction the drives should run when the alarm is triggered

2.4.5 Summary of the jumper settings

Jumper XB1 on the main circuit board

Alarm contacts Alarm, Fault and Window Open

2.5 Installation

2.5.1 Preparation

2.5.2 Assembly

2.5.3 Configuration

2.5.4 Electrical connection

Connecting components

Connecting the mains and batteries

2.6 Function test

2.7 Operating states and faults

Operating state codes

Lists and explains the codes displayed for operating states and faults.

2.9 Testing and maintenance

Test steps

Outlines the steps for performing system tests and maintenance.

3.2 Fuses