GFI System SYNESTHESIA - Dyna Flanger Algorithm; Speed and Depth (Delay) Controls; Tweak and Secondary Options

14
AlgorithmsReference
SYNESTHESIA

(FirmwareV2.0.x)
14.DynaFlanger
ModulationSpeed
[Tweak]=Mix
Controlsthewetanddrymix.
[Depth]=Delay(Manual)
ThisisourtakeontheclassicFlangereffect,themostversatileofallmodulationeffects.
The4availablemodes:
 Static:staticmodulationbyLFO(standardflanger).
 DynamicWidth(+):theflangingsweepswideraspickingstrengthincreases.
 DynamicWidth(‐):theflangingsweepswideraspickingstrengthdecreases.
 DynamicSweep:theflanginsweepfollowsthepickingdynamics.

Thisversatilealgorithmmaytakealittlemoretweakingtofullyunderstandwhattheparameters
aredoing,andwhatit’scapableof,butifyoutakethetimeyou’llberewarded:)
SP2‐Width:[0‐15]
(inStaticmode)

Sensitivity:[0‐15]
(inDynamicmode)
SP1‐Mode:
 StaticLFO
 DynamicWidth(+)
 DynamicWidth(‐)
 DynamicSweep
<Swirls>
Resonance(Feedback)parameter
Theresonanceparametergoesfrommaximum(‐)feedbacktomaximum(+)feedback.
 Settheknobatmidpointforzerofeedback(noresonance).
 Turnclockwiseformorepositive‐feedbackresonance.
 Turncounter‐clockwiseformorenegative‐feedbackresonance.

Delay(Manual)parameter
Thisparameterprovidemanualcontrolthedelaytimeshiftoftheflanger.
Usage:setWidthtozero,thenusetheDelayparametertomanuallysweepstheflanger.This
canbedoneeitherusinganexpressionpedalorrampingfunction(mappedtotheDepthknob).
PRIMARY SECONDARY
SP3‐Feedback:[‐8to+7]
Tap‐tempo/MidiClock 
NO