INTRODUCTION
This Operating Manual (hereinafter Manual or RE), that also includes certificate
data, applies to series of Capri refrigerated wall-sited undermount cabinets (hereinafter
referred to as cabinet or device). Data listed below provides information as well as
guidelines for consumers and maintenance specialists regarding:
− technical characteristics;
− manufacturer’s guarantees and certification;
− transportation and storage;
− installation, startup and operating the device (including maintenance and repairs),
disposal of the above mentioned cabinet.
WARNING: THE MANUFACTURER BEARS NO RESPONSIBILITY FOR ANY
KIND OF DAMAGE, CAUSED BY IMPROPER OR ERRONEOUS USE OF THE
CABINET, OR ANY OTHER ACTIONS THAT ARE NOT DIRECTLY SPECIFIED IN
THIS MANUAL.
1. GENERAL DATA
1. 1. Refrigeration cabinet is used for demonstration, short-time storage and selling
feed products, pre-cooled (frozen) to a temperature of effective volume is designed to
operate in trade and public catering enterprises.
1. 2. Refrigeration cabinet consists of the case and refrigerating unit, located in the
lower part of the cabinet.
The device is designed for storing the products in a temperature range, specified in
table 1 section 2 of this manual.
Basic technical specifications for the cabinets are provided in table 1 section 2 of
this manual.
1. 3. Climatic categories for the device according to GOST IEC 60335-2-89-2013:
‒ for devices with metal doors — 1 (t
air
=16С/80%), 2 (t
air
=22С/65%), 3 (t
air
=25С/
60%), 4 (t
air
=30С / 55%), 5 (t
air
=40С / 40%);
‒ for devices with glass doors — 1 (t
air
=16С/80%), 2 (t
air
=22С/65%), 3 (t
air
=25С/
60%), 4 (t
air
=30С / 55%).
The environment air humidity exceeding the sets parameters might cause condensed
water on the external device surface which does not constitute malfunction.
1. 4. The device meets the requirements for safety and environment protections,
listed in the following technical regulations, adopted by Customs Union:
1. 5. Average total service life of the device before reaching the limit state is at
least 12 years.
Limit state of a device is a state where frame deficiencies no longer allow to sustain
set temperature range on an acceptable level and economical losses caused by cost of the
repairs and idle time become comparable to the cost of a new device.
1. 6. The device can be transported by any types of transport, excluding air
transport, in a properly packed condition and meeting the transportation requirements,
standing for chosen type of transport. When transporting by means of an automobile
transport, the maximum allowed speed should not exceed 60 km/h (37m/h). Loading,
boarding, transportation, unloading should be executed carefully so as not to hit or push
the device. Packed device should be placed according to the markings on the label. Do
not tilt the package.
To Next Page
Loading...