Chapter 4 Digital Keypad Operation
VFD-E Series
4-2 Revision August 2006, 01EE, SW--PW V1.03/CTL V2.03
Display Message Descriptions
Display “End” for approximately 1 second if input has been accepted by
pressing
key. After a parameter value has been set, the new value is
automatically stored in memory. To modify an entry, use the
and
keys.
Display “Err”, if the input is invalid.
NOTE
When the setting exceeds 99.99 for those numbers with 2 decimals (i.e. unit is 0.01), it will only
display 1 decimal due to 4-digital display.
To Next Page
Loading...