Ghost AXWV - User Manual

AXWV WIRELESS VEHICLE SENSOR
OVERVIEW
Wireless Vehicle Sensor
Control Unit
Minimum of 20 Feet
Maximum of 100 Feet
from control board
sensor cable
WARNING: This product can expose you
to chemicals including lead, which is known
to the State of California to cause cancer.
For more information, go to
www.P65Warnings.ca.gov
WARNING: DO NOT USE THIS DEVICE WITH LIVESTOCK OR OTHER ANIMALS.
NOTE
THIS VEHICLE SENSOR ONLY WORKS WITH GHOST CONTROLS OPENER SYSTEMS.
PLEASE READ THE INSTRUCTIONS INCLUDED WITH THIS ITEM PRIOR TO INSTALLING.
IMPORTANT ITEMS REQUIRED
Two (2) C Alkaline Batteries are required and not included. One (1) Ghost Controls Transmitter that already operates the gate.
KIT CONTENTS:
■ 1 – Control Unit with control board (to be installed above ground)
■ 1 – Sensor Probe with 10 foot cable (to be buried below ground)
■ 1 – 12" PVC Pipe
PREPARING FOR INSTALLATION:
■ Must be located at least 20 feet beyond the path of the moving gate.
■ Must be located where the driver of the approaching vehicle has clear view of the gate.
■ Bury probe approximately 12" deep and as close to the driveway as possible for maximum detection of moving vehicles.
■ The Control Unit must be at least 6" above ground.
■ The Control Unit also should be with 100 feet of the Ghost Controls receiver/control box.
NOTE
The operating distance may vary depending on Radio Frequency interference at each installation site. Avoid installing the unit near
power lines, transformers or running motors.
PVC Pipe
Control Unit
Sensor Probe
Control Unit Cover

Summary

Important Items Required

Preparing For Installation

Setting Up Your Wireless Vehicle Control Unit Board

Battery Installation

Installing two C batteries into the control unit board with correct polarity for operation.

Teaching Transmitter to Unit

Pairing the remote transmitter with the control unit by pressing and holding the learn button.

Testing The Sensor Probe

Probe Detection Test

Moving a metal object over the sensor to verify detection and transmission via LEDs.

Installing Your Wireless Vehicle Sensor Probe and Control Unit

Installation Location Planning

Planning the optimal location for the sensor probe and control unit for best radio frequency range.

Trenching For Probe and Wire

Digging trenches for the sensor probe (12" deep) and the connecting wire.

Control Unit Hole Digging

Digging a 5"-6" deep hole for the control unit's PVC pipe.

Testing The Sensor By Driving Vehicle

Final Gate Operation Test

Testing the system by driving a vehicle past the sensor probe after installation.

Ghost AXWV Specifications

General

Brand	Ghost
Model	AXWV
Category	Gate Opener
Language	English