Page 18
SdMd - Selection of Sound mode
Press MENU to select SDMD, then press ENTER to start the adjustment. The display shows «SD1» to
«SD4». Select the desired Sound program with the UP & DOWN keys. Press ENTER to validate the selection.
Auto - Selection of automatic mode
Press the MENU button until Auto is displayed then press ENTER.
The display shows «AU1» to «AU4». Select the desired program with the UP & DOWN keys. Press ENTER to
validate the selection, then set the desired scrolling speed between “SP0” (slowest) and “SP9” (fastest) with
the UP & DOWN keys. Press ENTER to validate.
Sens - Adjustment of sound sensitivity:
Press MENU, select SENS and press ENTER to start setting. Use the UP AND DOWN keys to adjust the
sound sensitivity from 0-100. Press ENTER to validate.
Led - Adjusting the display backlighting.
Press MENU until LED is displayed and press ENTER. «ON», or «OFF» is displayed. Use the UP and DOWN
keys to select the function.
If ON is selected, the display will always remain on.
If OFF is selected, the display turns off after 2 minutes.
Press ENTER to conrm your choice then keep the key pressed for 3 seconds to conrm the change of
state.
Pan - Reverse Pan
Press MENU, select PAN and press Enter to congure the inversion. Press UP or DOWN to select
NO (normal pan rotation direction) or YES (reverse pan rotation direction), then press ENTER to conrm.
Tilt - Tilt inversion
Press MENU, select TILT and press Enter to congure the inversion. Press UP or DOWN to select
NO (normal tilt rotation direction) or YES (reverse tilt rotation direction), then press ENTER to conrm.
VER - Version display
Press MENU, select VER and press Enter to display the rmware version.
rSet - projector reset
Press MENU, select RESET and press Enter to conrm your choice then keep the key pressed for 3 se-
conds to conrm the projector reset.
To Next Page
Loading...
