Page 21
FUSE REPLACEMENT
Unplug the power cord from the device. Once the cord has been removed, locate the fuse holder located at
the IEC connector. Insert a athead screwdriver at the fuse holder and gently lift to remove the bracket from
the slot. Remove the bad fuse and replace it with a new one. (It is possible that the fuse holder includes a
housing for a replacement fuse, be sure to change the active fuse)
WARNING: ALWAYS USE A FUSE OF THE SAME VALUE!
Caution: If after replacing the fuse, the fuse continues to burn,
Contact customer service for further instructions.
Continuing to use the device can CAUSE SERIOUS DAMAGE.
CLEANING
Due to smoke and dust residues, the internal and external optics should be cleaned regularly to optimize the
light output.
• Clean the outer casing with a conventional cleaner and a micro-ber cloth.
• Clean the vents and fans with a brush.
• Clean the external optics with an optical cleaner or glass cleaner and a micro-ber cloth regularly
(depending on the atmosphere of the place).
• Clean internal optics with optical cleaner or glass cleaner and a micro-ber cloth every 30-60 days.
• Be sure to dry all parts before reconnecting the device to the mains.
In order to improve the products, technical changes can be made without prior information.
This is the reason why the technical characteristics and physical appearance of products may change.
To benet from the latest updates of our products, please log on to: www.ghost-france.com
To Next Page
Loading...
Need help?
General