9 10
If all of the above methods have been tried, the product still not work properly.
The internal circuit of the product may be out of order. Please return the
product to the supplier for maintenance.
13. TROUBLESHOOTING TIPS
Reduce a load power,or turn on the
appliance first, then turn on the
inverter. The inverter internal soft-start
circuit to buffer start the appliances.
1. Cut off the load and allow to cool for
10 to 30 minutes. Restart after it
reaches to normal temperature.
2. The load power is too large. Reduce
the total load power to the range of
rated power.
3. Avoid blocking the vent and improve
the ventilation condition.
4. Reduce the ambient temperature.
1. Use a true RMS multimeter to measure,
such as the model FLUKE 177/179.
2.Try to maintain the input voltage in the
range of rated power
3.Change the battery of the multimeter
then test again.
1. Do not use when the battery is
charging.
2. Check the rated voltage of the battery
and make sure that it is in the allowable
range of the input voltage.
1. Measured using true RMS
multimeter.
2. The battery power of RMS
Multimeter is low.
3. The input voltage is too
high or too low.
WARRANTY
This product is designed using the most modern digital technology and under
very strict quality control and testing guidelines.If,however, you feel this product is
not performing as it should, please contact us: support@giandel.com.au
We will do our best to resolve your concerns. If the product needs repair or
replacement, make sure to keep your receipt/invoice, as that will need to be sent
back along with the package and prepaid to GIANDEL .
This warranty is valid worldwide with the exception that freight and duty charges
incurred outside the contiguous 48 United States will be prepaid by customer.
Except as noted above, GIANDEL makes no warranty of any kind, express or
implied, including without limitation the implied warranties of merchantability and
fitness for a particular purpose. In no event shall GIANDEL be liable for indirect,
special or consequential damages. This warranty only applies to GIANDEL branded
products. All other name brand products are warranted by and according to their
respective manufacturer. Please do not attempt to return non-GIANDEL branded
products to us.
Warranty period: Please refer to the warranty card!
The following situations will void warranty:
1.The box is distorted, damaged or changed, and interior parts damaged
because of an exterior hit or drop not reported at time of delivery.
2.Connect the DC power incorrectly reversing the polarity.
3.Dismantled or repaired the unit by an unauthorized person.
4.The unit was damaged by incorrect installation or operating method.
For additional products, please visit our web site: www.giandel.com.au
-Modified sine wave inverters from 100W to 5000W
-Pure sine wave inverters from 200w to 5000W
To find out where to buy any of our products, you may also e-mail:
support@giandel.com.au
To Previous Page
Loading...
