Need help?Do you have a question about the Gianneschi MVG and is the answer not in the manual?
General safety, personnel qualifications, transport, and installation safety measures.
Addresses risks from non-compliance and importance of following safety instructions.
Safety during maintenance, inspection, mounting, and guidelines on modifications/spare parts.
Details on non-admitted functioning modes and pump limitations.
General guidance for maintenance and repair operations.
Procedures for ordering, inspecting, and repairing pumps, including hazardous materials.
Instructions for unpacking, inspecting the pump for damage, and checking the drive.
Guidelines for safe handling, lifting, and proper storage of the pump.
Covers pump rotating direction, admissible pressure, and pipe arrangement.
Requirements for electrical connections by qualified personnel.
Essential steps to perform before running the pump for the first time.
Preparatory steps before performing any maintenance on the pump.
Specific maintenance procedures for the MVI series pumps.
Specific maintenance procedures for the MVG series pumps.
Troubleshooting guide for issues where the pump fails to start.
Troubleshooting guide for issues where the pump is not drawing fluid.
Troubleshooting for pumps operating below expected performance levels.
Troubleshooting guide for identifying and resolving pump noise issues.
Troubleshooting guide for issues related to wear of pump components.
General| Self-Priming | Yes |
|---|---|
| Voltage | 230V |
| Connections | BSP |
| Frequency | 50 Hz |
| Inlet Diameter | 1" |
| Outlet Diameter | 1" |
To Next Page