How to troubleshoot Gianneschi ECOINOX C.E. Water Pump that does not start?
If the Gianneschi Water Pump doesn't start, begin by inspecting the wiring connections. Next, check the inlet piping. Finally, inspect the impeller.
What causes excessive pressure in Gianneschi ECOINOX C.E. system?
Excessive pressure in the Gianneschi Water Pump system can occur if the pump is oversized for the system or if the voltage is too high. Consider installing a pressure reducing valve.
Details the advantages and key features of the Control Press system for marine applications.
Covers safe lifting, moving, and initial checks before operating the pump.
Specifies the operating conditions and limitations for the electronic board.
Lists key technical data for the electric pump, including pressure, temperature, and protection indices.
How to use an expansion tank to reduce pump start-ups for minimal demands.
Describes pump behavior when a tap is opened and water is flowing.
Explains pump behavior when a tap is closed and pressure is restored.
Details how the pump stops in case of water shortage or dry running.
Recommends using a ball valve for testing pump and device operation during faults.
Lists common operating faults and their potential causes for the pump system.
Outlines essential safety measures before installation, maintenance, and operation.
General| Motor protection | IP 55 |
|---|---|
| Pump body material | Stainless Steel |
| Impeller material | Stainless Steel |
| Mechanical seal | Ceramic/Graphite |
| Voltage | 230V/400V |
| Frequency | 50 Hz |
| Material | Stainless Steel |
To Next Page
