Pag. -12-
5. Tightening torque.
The bolts used for the rear suspension (rear shock and pivots) are high-grade products and have been
tightened in the factory with specific torque. If it is necessary to remove or tighten the bolts, extreme care
should be taken when re-tightening them.
All bolts should be cleaned and re-set using Loctite
TM
primer (#7649) and Loctite
TM
blue Removable
Threadlock (#242).
For the location and tightening torque of all bolts please refer to the illustration below (fig. 6).
Location Tools needed Recommended tightening torque
Main pivot (BB - chain stays) 8 mm. Allen-keys, 2x 19~21 Nm.
Front shock mount
5 mm. Allen-key,
10 mm. wrench
9~11 Nm.
Rear shock mount
5 mm. Allen-key,
10 mm. wrench
9~11 Nm.
To Next Page
Loading...
