Appendix A: Setup Mode Service Procedures
There are additional setup mode functions for servicing that follow the same procedure as the setup
functions described in Chapter 7.
Caution: The following setup functions are servicing procedures, and are included for
completeness. Do not perform any of the following functions unless you are being instructed
on what to do by a Gibson service technician or Gibson tech support.
Functions 21-24 require the Dark Fire Configuration Tool. If needed, Gibson technical support will
provide you with additional information on obtaining and using this tool.
Function 8 Runtime correction: Set up Powerhead runtime correction Default = 1
Value Result Clickstream
0 Turns off runtime correction (not recommended) 8 § 0 §
1 Monitoring Powerheads generates correction data for different string gauges 8 § 1 §
Note: It takes up to 10 tunings to match the Powerhead movement to a specific string gauge
Function 21 Magnetic PU (left channel) PEQ settings: Configure 4-band EQ Default depends on sound
Result Clickstream
Configure a band of the magnetic pickup PEQ 21
§ coil configuration number
§ band number § config data
Example: To configure the left channel, PEQ Band1 for the Gibson Classic sound, use the clickstream 21 § 0 § 1 § 16.
You need the Dark Fire Configuration Tool to calculate the correct config data.
Function 22 Magnetic PU (left channel) PEQ settings: Configure EQ gain Default depends on sound
Result Clickstream
Configure gain for the magnetic pickups' 4-band PEQ 22
§ coil configuration number
§ band number § gain data
Example: To configure the left channel, PEQ Band1 gain for the Gibson Classic sound, use the clickstream 22 § 0 § 1 § 0.
You need the Dark Fire Configuration Tool to calculate the correct gain data.
Function 23 Piezo PU (right channel) PEQ settings: Configure 4-band EQ Default depends on sound
Result Clickstream
Configure a band of the magnetic pickup PEQ 23
§ coil configuration number
§ band number § config data
Example: To configure the right channel, PEQ Band1 for the Gibson Classic sound, use the clickstream 23 § 0 § 1 § 16.
You need the Dark Fire Configuration Tool to calculate the correct config data.“3. To Change the Piezo pickup
settings…..by the MCKs guitar symbol.
Gibson Dark Fire 4.0 manual, page 33
To Next Page
Loading...
