Gigabyte B365M H - Page 24

` Advanced Voltage Settings
` Advanced Power Settings
& CPU Vcore Loadline Calibration
 AllowsyoutocongureLoad-LineCalibrationfortheCPUVcorevoltage.Selectingahigherlevelkeeps
the CPU Vcore voltage more consistent with what is set in BIOS under heavy load. Auto lets the BIOS
automaticallycongurethissettingandsetsthevoltagefollowingIntel'sspecications.(Default:Auto)
` CPU Core Voltage Control
This section provides CPU voltage control options.
` DRAM Voltage Control
This section provides memory voltage control options.
` Internal VR Control
 ThissectionprovidesVRvoltagecontroloptions.
` PC Health Status
& Reset Case Open Status
Disabled  Keepsorclearstherecordofpreviouschassisintrusionstatus.(Default)
Enabled Clears the record of previous chassis intrusion status and the Case Openeldwill
show"No"atnextboot.
& Case Open
 DisplaysthedetectionstatusofthechassisintrusiondetectiondeviceattachedtothemotherboardCI
header.Ifthesystemchassiscoverisremoved,thiseldwillshow"Yes",otherwiseitwillshow"No".To
clear the chassis intrusion status record, set Reset Case Open Status to Enabled, save the settings to
the CMOS, and then restart your system.
& CPU Vcore/CPU VCCSA/DRAM Channel A/B Voltage/+3.3V/+5V/+12V/CPU VAXG
 Displaysthecurrentsystemvoltages.
` Miscellaneous Settings
& Max Link Speed
Allows you to set the operation mode of the PCI Express slots to Gen 1, Gen 2, or Gen 3. Actual operation
modeissubjecttothehardwarespecicationofeachslot.AutoletstheBIOSautomaticallycongurethis
setting.(Default:Auto)
& 3DMark01 Enhancement
 Allowsyoutodeterminewhethertoenhancesomelegacybenchmarkperformance.(Default:Disabled)
` Smart Fan 5 Settings
& Monitor
 Allowsyoutoselectatargettomonitorandtomakefurtheradjustment.(Default:CPUFAN)
& Fan Speed Control
Allows you to determine whether to enable the fan speed control function and adjust the fan speed.
Normal Allows the fan to run at different speeds according to the temperature. You can adjust
the fan speed with System Information Viewer based on your system requirements.
(Default)
Silent Allows the fan to run at slow speeds.
Manual Allows you to control the fan speed in the curve graph.
Full Speed Allows the fan to run at full speeds.
- 24 -