Gigabyte G1.Sniper 5 - Page 76

Conguring SATA Hard Drive(s)
- 76 -
Figure 6
Figure 7
When completed, you can see the new array under Topology\Virtual Disks (Figure 6).
5. Save the Settings and Exit. After you complete the RAID conguration and before you exit the conguration
screen, be sure to press <F10> in the main screen. Press <Y> to conrm or <N> to cancel (Figure 7). Now,
you may proceed to the installation of the SATA driver and operating system.
Marvell BIOS Setup (c) 2011 Marvell Technology Group Ltd.
Topology Information
Help
Vendor ID : 1B4B
Device ID : 9230
Revision ID : A0
BIOS Version : 20291.24369.82.6535
Firmware Version : 2.3.0.1046
PCIe Speed rate : 5.0Gbps x2
Congure SATA as : AHCI Mode
Supported Mode : RAID 0 RAID 1 RAID10
: Capacity Safe
HBA 0 : Marvell 0
Virtual Disks
New_VD
HDD 0: ST95005620AS
HDD 1 : ST95005620AS
Free Physical Disks
Marvell RAID on chip controller.
ENTER: Operation F10: Exit/Save ESC: Return
Marvell BIOS Setup (c) 2011 Marvell Technology Group Ltd.
Topology Information
Help
Vendor ID : 1B4B
Device ID : 9230
Revision ID : A0
BIOS Version : 20291.24369.82.6535
Firmware Version : 2.3.0.1046
PCIe Speed rate : 5.0Gbps x2
Congure SATA as : AHCI Mode
Supported Mode : RAID 0 RAID 1 RAID10
: Capacity Safe
HBA 0 : Marvell 0
Virtual Disks
New_VD
HDD 0: ST95005620AS
HDD 1: ST95005620AS
Free Physical Disks
Marvell RAID on chip controller.
ENTER: Operation F10: Exit/Save ESC: Return
Do you want to exit from Marvell BIOS Setup?
Yes No
Exit