Gigabyte G1.Sniper - Page 11

- 11 - Hardware Installation
Storage Interface JMicronJMB362chip: 
- 2 x eSATA 3Gb/s connectors (eSATA/USB Combo) on the back panel,
supporting up to 2 SATA 3Gb/s devices
 - SupportforSATARAID0,RAID1,andJBOD
USB South Bridge: 
- Up to 12 USB 2.0/1.1 ports (6 on the back panel, including 2 eSATA/USB
Combo, 6 via the USB brackets connected to the internal USB headers)
1 x  Renesas D720200 chip and 2 x VLI VL810 hubs:
- Up to 4 USB 3.0/2.0 ports (2 on the back panel, 2 via the USB bracket
connected to the internal USB header)
* The USB 2.0 signals of the USB 3.0/2.0 ports on the back panel are from the South
Bridge.
Internal
Connectors
1 x 24-pin ATX main power connector 
1 x 8-pin ATX 12V power connector 
2 x SATA 6Gb/s connectors 
6 x SATA 3Gb/s connectors 
1 x CPU fan header 
1 x system fan header 
3 x fan headers 
1 x front panel header 
1 x front panel audio header 
1 x S/PDIF Out header 
3 x USB 2.0/1.1 headers 
1 x USB 3.0/2.0 header 
1 x clearing CMOS jumper 
1 x heatsink LED power connector 
Back Panel
Connectors
1 x PS/2 keyboard port 
1 x PS/2 mouse port 
1 x optical S/PDIF Out connector 
1 x coaxial S/PDIF Out connector 
1 x CPU overclocking button 
4 x USB 2.0/1.1 ports 
2 x USB 3.0/2.0 ports 
2 x eSATA/USB Combo connectors 
1xRJ-45port 
5 x audio jacks (Center/Subwoofer Speaker Out, Rear Speaker Out, Side Speaker 
Out, Line In/Mic In, Line Out)
I/O Controller iTE IT8720 chip 
Hardware
Monitor
System voltage detection 
CPU/System temperature detection 
CPU/System fan speed detection 
CPU overheating warning 
CPU/System fan fail warning 
CPU/System fan speed control 
* Whether the CPU/system fan speed control function is supported will depend on
the CPU/system cooler you install.